Pro-Form PFTL59518.3 User Manual page 32

SYMPTOM: The walking belt slips when walked on
a. First, remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walking
belt is correctly tightened, you should be able to lift
each edge of the walking belt 2 to 3 in. (5 to 7 cm)
off the walking platform. Be careful to keep the
walking belt centered. Then, plug in the power
cord, insert the key, and walk on the treadmill for a
few minutes. Repeat until the walking belt is
properly tightened.
a
SYMPTOM: The tablet holder does not stay in place
a. Rotate the tablet holder (B) until it faces backward.
Then, tighten the indicated screw (C) slightly until
the tablet holder stays in place when it is rotated to
the desired position.
a
B
C
32
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (D) port on the
console. Using a bent paper clip (E), press and
hold the reset button inside the opening, and have
a second person press the power switch into the
on position. Continue holding the reset button until
the console turns on. When the reset operation is
complete, the console will turn off and then turn
back on. If it does not, use the power switch to
turn the treadmill off and then on again. Once the
console turns on, check for fi rmware updates (see
HOW TO USE THE MAINTENANCE SECTION on
page 26). Note: It may take a few minutes for the
console to be ready for use.
a
D
E