Table of Contents
Advertisement
17. Tighten the eight indicated Screws (2, 3, 4).
18. Press the two tabs on the Tablet Holder (91) into
the slots (O) in the console assembly (K).
Attach the Tablet Holder (91) with four M4 x
16mm Screws (90). Note: Start the two top
Screws fi rst, and then start the two bottom
Screws. Be careful not to overtighten the
Screws.
IMPORTANT: The Tablet Holder (91) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see pages 31 and 32). Note: Extra hardware may be
included.
17
2, 3, 4
18
Start First
90
16
2, 3, 4
91
K
O
Advertisement
Table of Contents
