6. Remove and save the four indicated 5/16" x
3/4" Screws (13).
7. Turn one of the Handrails (72) upside down.
Insert a 5/16" x 1 1/2" Screw (5) with a 5/16" Star
Washer (7) into the indicated large hole (F) and
out of the indicated small hole (G).
Next, hold the 5/16" x 1 1/2" Screw (5) with the
hex key (H) and turn the Handrail (72) upright.
Continue to hold the Screw in place as you
complete the next assembly step.
8. Set the Handrail (72) on the Right Upright (79).
Inset the hex key (H) into the indicated hole and
partially tighten the 5/16" x 1 1/2" Screw (5); do
not fully tighten the Screw yet.
Next, start another 5/16" x 1 1/2" Screw (5) with
a 5/16" Star Washer (7) into the Handrail (72)
and the Right Upright (79); then, tighten both
Screws. Make sure not to pinch the Upright
Wire (80).
Then, remove and discard the two indicated
screws (I).
Repeat step 7 and this step to attach the
other Handrail (not shown) to the Left Upright
(78). Note: There are no wires on the left side.
6
13
7
G
F
H
8
78
11
13
72
7
5
5
7
I
72
H
5
79
80