Home >
Paper Handling
Paper in Tray #1
Load A3, Ledger, or Legal Size Paper in Tray #1
•
If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message
appears on the LCD, allowing you to change the paper size and paper type.
•
When you load a different paper size in the tray, you must change the Paper Size setting in the machine or
the paper size setting on your computer.
•
Glossy photo paper will not be an option in Tray #1 when using this method.
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2
2. Pull the paper tray completely out of the machine as shown by the arrow.
3. Remove the tray top cover (1).
4. Rest the tray on a flat surface.
Push the green slider to the left and then extend the tray until it locks into place.
>
Load Paper
>
Load Paper in the Paper Tray
1
1
> Load A3, Ledger, or Legal Size
32