THOMSON THT712 User Manual page 22

PIN Code Change:
Old PIN Code:
New PIN Code:
Confirm:
7.3.5 Time Settings
Here you can set up your time zone for clock/time in your menu and system.
Use pq to move the highlight to the setting of choice. Values can be changed with t u. Press
 to leave.
GMT Usage:
GMT Offset:
Daylight Saving:
7.3.6 Timers
This menu allows you to set up to 10 timed events for waking up the receiver.
Use pq to select Timer from the Settings menu and press OK to enter.
The receiver will display a list with 10 timers, followed by their respective status. Select the timer
you wish to set or change with pq and press OK to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Status:
Timer Action:
Channel:
Start Date:
Start Time:
Duration:
Event Name:
18
Press OK to enter the menu.
Enter your current PIN code (4 digits).
Enter your new PIN code (4 digits) you'd like to use.
(Make a note of it.)
Re-enter your new PIN code to confirm. Press OK to end and save the
change.
Set to Auto for broadcaster defined time depending of country selection
you made in the First Installation Wizard. Normally, the clock/time will
be correct and also follow up the summer time changes automatically.
In some regions close to neighbouring countries it can happen that the
wrong time zone is followed. In this case select the option User Defined
to set up time manually in the next steps below.
Allows you to adjust the time zone you live in. This option is only available
when GMT Usage is set to User Define.The GMT Offset range is "-11:00 ~
+12:00".
Select Off or On to add one hour extra for summer time.
Choose between Once, Monday ~ Friday, Daily and Weekly Timer or
select Off, then Timer will execute the scheduled event.
Select Booking to wake-up the receiver and switch to the selected
channel. Select Recording to start record from the selected event to an
externally connected USB device.
Press OK to open the channel list and use pq to select the channel
where the timer will wake up with.
Use the 0~9 buttons to enter the date for the timed event.
Use the 0~9 buttons to enter the start time.
Use the 0~9 buttons to enter the timer duration.
Displays, after you have saved the timer, the event name according to the
EPG. This is only possible if EPG is available.