Error Messages / Malfunctions - BIOS Diagnostics Protocol 7D Instruction Manual

The classification is based on standards adopted by
Hypertension Canada.
The indicator bar rises according to your measurement.
measurement is in the green zone, or "Normal".
or "High Normal".
Blood Pressure with Self / Home Monitoring".
"Moderate to Severe Hypertension".
This blood pressure monitor allows you to set two alarm times at which an alarm signal will then be triggered.
This can be a useful aid, for instance as a reminder to take your measurements for the Protocol Software (7D
Mode) or to remind you to take medication.
1. To set the alarm, while the monitor is OFF, press the SET button 8 times, "AL OFF 1
or "-" buttons to switch between the alarm being OFF or ON. Select "AL ON 1" and press the SET button. The
3. Once Alarm 1 is set, you can follow the same steps above to set Alarm 2.

4. Error Messages / Malfunctions

If an error occurs during a measurement the LCD displays the corresponding error code.
Error Possible Cause
Weak signal or a sudden change in pressure
External disturbance (eg. if there is a cell
phone near by)
Appears when there is an error during the
Abnormal Blood Pressure
In 7D Mode - Protocol was not done correctly
Low battery
If problems occur when using the device the following points should be checked, and if necessary, the
corresponding measures should be taken.
"+" or "-" buttons to change the HOUR digits, press SET button to confirm.
"+" or "-" buttons to change the digits, press SET to confirm.
14 5
Red
135-14 5
Red
121-134
Yellow
Green 110-120
Green
Ensure that the cuff is worn correctly and
measure again. Avoid movement or talking
Electromagnetic interferance can cause odd
behaviour in the monitor. Move away from
the source.
Make sure the cuff is wraped around the
arm properly and that the air plug is properly
connected to the unit.
Rest for 5 minutes and try measurement
again.
Delete all measurements from the memory.
Start Protocol again. Take 4 measurements a
day ( 2 in the morning, 2 in the evening) for 7
days straight.
Replace batteries.
SYS DIA
(mmHg)
95
85-95
80-84
71-80
110
70
"+"