Clear Measurements From Memory - BIOS Diagnostics Protocol 7D Instruction Manual

First select 7D Mode, then press the "+" or "-" button.
A. If the Protocol was done correctly, the monitor will display "
been saved in the memory, and then display the Average Measurement as per the Protocol software. In the
Average Measurement screen the date will display the second day the Protocol measurements were started
and then change to the 7
If the first day of measurements are started on October 10th and ends 7 days later on October
17th, the date will appear as 10
of 10 10 because the Protocol disregards the first day of measurements and averages the last 6 days of
M D
measurements, see section 3.4 for more explanation.
Press the "+" or "-" button to display the subsequent measurements.
7D mode General mode
B. If the Protocol was done incorrectly or if any measurements were missed, the monitor will display "
then " " then the average measurement and then display the subsequent measurements.
7D mode General mode
- Not enough measurements have been saved in memory. For the Protocol Software to work correctly there
needs to be 28 measurements saved in memory, 4 measurements taken for 7 days.

3.9 Clear Measurements From Memory

If you are sure that you want to permanently remove all stored memories, first choose the mode you want to delete
the memory from, then press the SET button 9 times until "
STOP button until "
CL
symbols " " and "
no
The bars on the left hand side of the display show you the range within which the indicated blood pressure
values lies. Depending on the height of the bar, the readout value is either within the normal (green), borderline
(yellow) or danger (red) range.
day the Protocol measurements ended.
th
11 then change to 10
M D
7D mode General mode
7D mode General mode
" flashes 3 times to clear the memory. After this, press either the "+" or "-" button, the
" will appear on the screen. This means that the memory has successfully cleared.
", meaning all 28 measurements have
17 and back and forth . 10
M D
7D mode General mode 7D mode General mode
7D mode General mode 7D mode General mode
" appears when the power is off. Press the
CL
11 will display instead
M D
7D mode General mode
7D mode General mode
"