Section 7 − Dynasty 280 Dx Operation; Dynasty 280 Dx And Dynasty 280 Dx Multiprocess Controls - Miller Maxstar 280 Owner's Manual

SECTION 7 − DYNASTY 280 DX OPERATION
7-1.

Dynasty 280 DX And Dynasty 280 DX Multiprocess Controls

1
7
.
For all front panel switch pad controls:
press switch pad to turn on light and
enable function.
.
Green on nameplate indicates a TIG
function, Gray indicates
function.
1 Standby Button
Use to put machine into low power
consumption mode.
.
This button can also be used to clear
some errors. See Section 11-3.
2 Encoder Control
Use encoder control in conjunction with ap-
plicable front panel function switch pads to
change values for that function.
.
A complete Parts List is available at www.MillerWelds.com
4
3 Memory Card Port And Indicator
This port is used to add features to the ma-
chine and update software to the boards
within the machine. Indicator is lit while card
is being accessed.
a Stick
4 Volt Meter
Stick and TIG - Displays actual rectified av-
erage voltage when voltage is present at the
weld output terminals.
MIG/V-Sense (Multiprocess Models) - Dis-
plays output polarity while idle or adjusting
and actual voltage while welding.
While in the menu it is used to display pa-
rameter descriptions.
3
5
5 Ammeter / Parameter
Stick and TIG - Displays preset amperage
while idle and actual rectified average am-
perage while welding.
MIG/V-Sense (Multiprocess Models) - Dis-
plays preset voltage while idle or actual rec-
tified amperage while welding.
While in the menu it is used to display pa-
rameter selection options.
6 Amperage
Use this control in conjunction with the en-
coder to set the average weld amperage or
peak amperage if the Pulser is active.
7 V-Sense Feeder (Multiprocess
Models)
Use item 6 and 2 to set constant voltage
when the V-Sense Feeder - DC MIG
(GMAW/FCAW) process is selected.
2
6
280589-A
OM-253086 Page 37