Section 7 - Dynasty 210 Dx Operation; Dynasty 210 Dx Controls - Miller Maxstar 210 Owner's Manual

SECTION 4
SECTION 7 – DYNASTY 210 DX OPERATION
4-1.

Dynasty 210 DX Controls

7-1. Dynasty 210 DX Controls
1
�
For all front panel button controls:
press button to turn on light and ena-
ble function.
�
Green on nameplate indicates a TIG
function, Gray indicates
function.
1 Standby Button
Use to put machine into low power con-
sumption mode.
�
This button can also be used to clear
some errors. See Section 12-5.
2 Amperage Adjustment Control
DYNASTY 210 DX OPERATION
�
Complete Parts List is available at www.MillerWelds.com
4
Use amperage adjustment control in con-
junction with applicable front panel function
buttons to change values for that function.
3 Memory Card Port And Indicator
a Stick
This port is used to add features to the ma-
chine and update software to the boards
within the machine. Indicator is lit while card
is being accessed.
4 Voltmeter
Displays actual rectified average voltage
when voltage is present at the weld output
3
5
247220-D
terminals. It is also used to display parame-
ter descriptions while in the menu.
5 Ammeter
Displays actual amperage while welding and
preset amperage while idle. It is also used to
display parameter selection options while in
the menu.
6 Amperage Button
Use this button in conjunction with the am-
perage adjustment control to set the aver-
age weld amperage or peak amperage if the
Pulser is active.
2
6
OM-270536 Page 21
OM-270536 Page 37