Checking The Rear Shock Absorber Assembly; Adjusting The Rear Shock Absorber Assembly - Yamaha YZ250X 2023 Owner's Manual

to modify the specifications as necessary.
Air bleeding from front fork
TIP
If the front fork initial movement feels stiff during
a run, relieve the front fork internal pressure.
1. Use a maintenance stand to raise the front
wheel off the ground.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove the bleed screw "1" and release the
internal pressure from the front fork.
3. Tighten:
• Bleed screw
Bleed screw (front fork)
1.3 N·m (0.13 kgf·m, 0.95 lb·ft)
EAM30482
CHECKING THE REAR SHOCK ABSORBER
ASSEMBLY
1. Stand the vehicle upright on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Check:
• Rear shock absorber assembly
Gas leaks/oil leaks  Replace the rear shock
absorber assembly.
Refer to "REAR SHOCK ABSORBER AS-
SEMBLY" on page 4-28.
3. Check:
• Rear shock absorber assembly smooth ac-
tion
• Rear suspension link smooth action
Sit astride the seat and shake your body up
and down several times to check whether the
rear shock absorber assembly operates
smoothly.
Unsmooth operation  Correct or replace.
EAM30242
ADJUSTING THE REAR SHOCK ABSORBER
ASSEMBLY
Use a maintenance stand to raise the rear wheel
off the ground.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
Spring preload
ECA24360
NOTICE
Do not turn the adjuster forcibly beyond its
adjusting range.
1. Remove:
• Rear frame
2. Adjust:
• Spring preload
a. Loosen the locknut "1".
b. Loosen the adjuster "2" until there is some
clearance between the spring and the ad-
juster.
c. Measure the spring free length "a".
d. Turn the adjuster in the direction of "b" or
"c" to make an adjustment.
3-20
CHASSIS