Yamaha YZ250X 2023 Owner's Manual page 81

clamp should be installed according to the di-
mensions shown.
• Pass the engine stop switch lead in the middle
of the clutch lever holder.
0 mm
(0 in)
7. Install:
• Clutch cable "1"
TIP
Apply the lithium-soap-based grease on the
clutch cable end.
8. Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-7.
9. Install:
• Right grip "1"
Apply the adhesive on the tube guide "2".
TIP
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface "a" with a lac-
quer thinner.
• Align the mating mark "b" on the right grip with
0 mm
(0 in)
1
4-11
the slot "c" in the tube guide.
10.Install:
• Grip cap (upper) "1"
• Grip cap (lower) "2"
• Grip cap bolt "3"
TIP
Temporarily tighten the grip cap bolts.
11.Install:
• Collar "1"
• Grip cap cover "2"
• Throttle grip "3"
TIP
• Apply the lithium-soap-based grease on the
throttle grip sliding surface.
• Tighten the grip cap bolts temporarily without
the throttle being fixed to the handlebar.
HANDLEBAR