B - On/Off Key; C - Fan Speed; D - Timer Function; E - Activation Of The Display - Olimpia splendid AQUARIA 14P Instructions For Installation, Use And Maintenance Manual

3.2.b - ON/OFF key

Press the ON/OFF key (D6) and the appliance switches on, the display shows the percentage of humidity
detected.
To switch off the appliance, press the key ON/OFF (D6) again.

3.2.c - Fan speed

Press the "Speed" key (D1) to be able to select the fan speed:
Once fan speed is selected, the respective Led (L1) remains on.
If "LAUNDRY" mode is active, fan speed cannot be changed.

3.2.d - Timer function

Press the "Timer" (D2) key to set the delay time for "ON" (start) or "OFF" (switch off) modes.
In "ON" mode, press the "Timer" (D2); key once or more; the display shows the delay time for the appli-
ance switch off in hours (0 -> 1 -> 2 -> .... -> 23 -> 24 -> 0 -> 1 -> ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value
after which the appliance switches off (OFF); the (L2) led switches on in green.
In "OFF" mode, press the "Timer" (D2); key once or more; the display shows the delay time for the ap-
pliance start in hours (0 -> 1 -> 2 -> .... -> 23 -> 24 -> 0 -> 1 -> ....).
Once the desired value has been selected, wait a few seconds to allow the memorization of the set value
after which the appliance starts (ON); the (L2) led switches on in green.
To cancel the Timer function programming, press the "Timer" (D2)key once or more until selecting "0"
or press the "ON/OFF" (D6) key.

3.2.e - Activation of the display

Press the "Setting level of humidity" (D4) and "Led" (D3) keys simultaneously, the detected room
temperature appears on the display.
Press the "Led" key (D3), the display and the active Led switch off, the machine continues to work.

3.2.f - Humidity level setting

Press the "Setting level of humidity" key (D4) to select the desired level of humidity in the room:
"CO" (Continuous cycle) ---> 30% ---> 35% ---> ... ---> 85% ---> 90% ---> "CO" (Continuous cycle) ---> ..
The settable value must be included between 30% and 90 % with 5% intervals.
After a certain period of operation, when the percentage of humidity in the room is lower than the set
value, the compressor stops temporarily.
EN - 18
High. -- > Med. -- > Min. -- > High. -- > ...