Checking The Basic Position Of The Shift Lever; Adjusting The Basic Position Of The Shift Lever - Husqvarna FE 501s 2022 Owner's Manual

17.6

Checking the basic position of the shift lever

Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
17.7

Adjusting the basic position of the shift lever

Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Allow the vehicle to run at idle speed.
The malfunction indicator lamp stops flashing once pro-
gramming is completed.
Info
If the engine becomes too warm, perform a cool-down
ride at medium speed.
After this, do not switch off the engine, but leave it
running at idle speed until the programming is fin-
H02263-10
ished.
–
Sit on the vehicle in the riding position and determine
A
distance
shift lever.
Gap between the shift lever
and the top of the boot
» If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
( p. 125)
400692-10
–
Remove screw
2
lever .
401950-12
TUNING THE ENGINE 17
between the upper edge of your boot and the
10 ... 20 mm (0.39 ...
0.79 in)
1
with the washers and take off shift
125