Husqvarna FE 501s 2022 Owner's Manual page 79

SERVICE WORK ON THE CHASSIS 12
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides in
front of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or
damaged.
H03706-11
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Position the horn with the horn bracket.
H03704-11
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H03705-11
–
Plug in connector
–
Remove the wash cap set.
–
Clean the quick release coupling thoroughly with compressed
air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
F03551-11
–
Spray silicone spray onto a lint-free cleaning cloth and lightly
lubricate the O-ring of the quick-release coupling.
Silicone spray (
–
Join quick release coupling
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
–
Install the right side cover. (
–
Mount the seat. (
p. 83)
1
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
2
.
M6 10 Nm (7.4 lbf ft)
3
for the fuel pump.
p. 150)
4
.
p. 71)
p. 67)
77