How To Find Your Tv's Video Input Channel - RCA VR650HF User Manual

Appendix: reference
How to Find Your TV's Video Input
Channel
You need to tune your TV to the Video Input Channel if you are
using the VCR's AUDIO/VIDEO OUT jacks to connect to the TV's
AUDIO/VIDEO INPUT jacks. You must select this "channel" before
you can see the VCR's menus, the cable or antenna reception,
and the content that's on a tape.
The Video Channel on TVs varies for different brands and
different models. Below are some steps to try:
• If your TV brand is RCA, GE, or PROSCAN, press the TV button
on the remote control that came with the VCR. Then press
the INPUT button on the remote.
• If you have another brand of TV, consult the section,
Programming The Remote, to see if the VCR's remote control
can be set to control your TV. If so, follow the step above.
If those options do not work, try the following ideas. You might
access the Video Input Channel by:
• pressing a button on the remote (see table below)
• selecting the channel from the TV's menu system
(see table below)
• tuning directly to the channel by selecting a specific channel
number (see table below)
• going through all the channels in the channel list by pressing
the channel up or down buttons on the TV.
Some common scenarios are listed in the Video Input Channel
Variations table that follows:
Video Input Channel Variations
Button/Switch
on the TV
VIDEO
SIGNAL
VID 1
VID 2
S-VID
S-VIDEO
58
Button on the Channel
TV Remote Number
VID 1 00
LINE 90
VID 91
VIDEO 92
S-VID 93
INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX
TV
Button
ON•OFF
TV
REVERSE PLAY
RECORD STOP
INFO
MUTE
CLEAR MEN
1 2
5
4
7 8
INPUT
0
Button
– TRACKING +
VCR
FORWARD
PAUSE
SEARCH
GO BACK
SPEED
3
6
9
F.ADV