HIKOKI DV 36DA Handling Instructions Manual
  1. Manuals
  2. Brands
  3. HIKOKI Manuals
  4. Drill
  5. DV 36DA
  6. Handling instructions manual

HIKOKI DV 36DA Handling Instructions Manual

Hide thumbs Also See for DV 36DA:
Table of Contents

Advertisement

Quick Links

Download this manual
DS 36DA • DV 36DA
DS36DA
DV36DA
Handling instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DV 36DA and is the answer not in the manual?

Questions and answers

Related Manuals for HIKOKI DV 36DA

Summary of Contents for HIKOKI DV 36DA

  • Page 1 DS 36DA • DV 36DA DS36DA DV36DA Handling instructions...
  • Page 2 &...
  • Page 3 Min. Max. DV36DA DS36DA DV36DA...
  • Page 4 DS36DA, DV36DA: 500 /min Hs 2100 /min...

  • Page 6: General Power Tool Safety Warnings

    power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on.

  • Page 7: Additional Safety Warnings

    c) When battery pack is not in use, keep it away 10. Bring the battery to the shop from which it was purchased from other metal objects, like paper clips, coins, as soon as the post-charging battery life becomes too keys, nails, screws or other small metal objects, short for practical use.

  • Page 8: Regarding Lithium-Ion Battery Transportation

    In the cases of 1 to 3 described below, when using this WARNING product, even if you are pulling the switch, the motor may stop. If a conductive foreign matter enters in the terminal of lithium This is not the trouble but the result of protection function. ion battery, the battery may be shorted, causing fi...

  • Page 9: Standard Accessories

    * Existing batteries (BSL3660/3620/3626, BSL18xx and Drilling BSL14xx series) cannot be used with this tool. NOTE Impact drilling Due to HiKOKI’s continuing program of research and development, the specifi cations herein are subject to Switching ON change without prior notice.
  • Page 10 3. Charging CHARGING When inserting a battery in the charger, the charge indicator lamp will blink in blue. Before using the power tool, charge the battery as follows. When the battery becomes fully recharged, the charge 1. Connect the charger’s power cord to the receptacle. indicator lamp will light up in green.

  • Page 11: Mounting And Operation

    Charging a USB device from a Regarding electric discharge in case of new batteries, 15-a electrical outlet etc. Charging a USB device and 15-b As the internal chemical substance of new batteries and battery from a electrical outlet batteries that have not been used for an extended period How to recharge USB device is not activated, the electric discharge might be low when using them the fi...

  • Page 12: Maintenance And Inspection

    4. Inspection of terminals (tool and battery) Check to make sure that swarf and dust have not collected on the terminals. Important notice on the batteries for the HiKOKI On occasion check prior, during and after operation. cordless power tools...

  • Page 13: Troubleshooting

    TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. 1. Power tool Symptom Possible cause Remedy Tool doesn’t run No remaining battery power Charge the battery.
  • Page 14 The charger’s vents are blocked, causing its Avoid blocking the vents. internal components to overheat. The cooling fan is not running. Contact a HiKOKI Authorized Service Center for repairs. The USB power lamp The battery’s capacity has become low. Replace the battery with one that has has switched off...
  • Page 15 DS36DA DV36DA /min 0 - 500 0 - 500 /min 0 - 2100 0 - 2100 /min ― 0 - 7500 /min ― 0 - 31500 ― 1.5 - 13 1.5 - 13...
  • Page 16 DS36DA, DV36DA (2XCP) (2XCK) (NN) ― UC18YSL3 ― BSL36A18 ― ― ― ― ―...
  • Page 17 BSL36A18 339778 UC18YSL3 (14.4V - 18V) 336471 371797 339776 983006 329897...
  • Page 20 Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99723112 G Printed in China...

This manual is also suitable for:

Ds 36da

Table of Contents