Table of Contents
Advertisement
Aktor M
Operation
6.3
Initialisation run
After remounting or after changing the setting of the
maximum flow rate on the valve, a new valve adaptation
must be carried out by reinitialisation.
f
Switch DIP switch A5 back and forth (change switch
position).
Z
The actuator performs a re-initialisation.
18
7.
Operation
7.1
Operating mode selector switch
Operating mode
Setting
Automatic mode
With the cover in place, set the
operating mode selector switch to
automatic mode
in Fig. 2 on page 9)
Manual
With the cover in place, set the
adjustment
operating mode selector switch to
manual adjustment
4 in Fig. 2 on page 9)
7.2
External operating mode selector
switch (manual mode)
An external operating mode selector switch (par. 5.3.1.5 on
page 14) can be used to switch between automatic
mode, Stop, Closed and Open.
7.3
Superimposition through DIP
switches
Operating mode
Setting
Automatic mode
Operating mode selector switch
to manual adjustment
DIP switch A4 to ON.
When the cover has been
removed, automatic mode can be
activated by setting DIP switch A4
to ON. This function is only
permitted for qualified
tradespeople.
Manual
Operating mode selector switch
adjustment
to automatic mode
switch A4 to ON.
7.4
Manual adjustment
If the operating mode manual adjustment has been
activated, the valve can be adjusted at the handwheel of
2
the actuator (position
in Fig. 1 on page 7).
(position 2
(position
and
and DIP
115802384-V01.10.2022
Advertisement
Table of Contents
