Notices; Warranty; Regulatory Certifications; Safety Warnings - Markes International HiSorb Agitator Instructions For Use Manual

Table of Contents

Advertisement

QUI-1124

2. Notices

2.1. Warranty

The HiSorb Agitator is designed for laboratory use only. It is not intended for use in domestic
establishments or establishments directly connected to a low-voltage power supply network that supplies
buildings used for domestic purposes.
Where the HiSorb Agitator is used in a field environment, care must be taken to
ensure that it is not exposed to detrimental conditions, i.e. rain, wind, or sun. Exposure may diminish the
performance, cause damage to the instrument, and/or cause the instrument to become unsafe to the
user.
If the instrument is not used in a way specified by the manufacturer, the protection provided by the
instrument may be reduced. System failures arising from such use may not be covered in standard
warranty and service contract documents.

2.2. Regulatory certifications

The instrument is designed and manufactured under a quality system registered to ISO 9001.

3. Safety warnings

3.1. Symbols

Make sure you follow the safety notices presented in this manual and follow warning symbols on the
product. Markes International assumes no liability for the failure to comply with these requirements. The
following terms are used in this manual:
WARNING
This highlights actions that could cause personal injury.
CAUTION
This highlights actions that may cause damage to hardware or software, render test results
invalid, or result in non-optimal performance.
NOTES
This emphasises important information about a specific task.

3.2. Mains voltages/External power supply

WARNING
Ensure that the plug (electrical isolator) can be easily and quickly accessed during
equipment use.
WARNING
The instrument must be suitably earthed.
WARNING
The internal parts of the HiSorb Agitator are all low-voltage. However, the external power
supply will contain potentially dangerous voltages (even if the power switch is off) – never
remove the cover of the external power supply.
CAUTION
To reduce risk of damage, position the power supply unit away from the agitator and any
liquids.

3.3. Liquid handling

WARNING
Flammable and/or explosive liquids must not be used with the agitator. Use of
these substances will render safety approval of the agitator invalid, and may
cause serious injury and/or damage.
WARNING
To avoid injury, observe safe laboratory practice when handling solvents and
samples, and observe company policy on safety at all times.
Page 4
www.markes.com

Advertisement

Table of Contents
loading

Table of Contents