3. BEFORE FIRST USE
3.1 Initial Cleaning
Step 1
Remove all accessories and
removable shelf supports from
the oven.
3.2 First connection
The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.
3.3 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Clean the oven and the ac‐
cessories with a soft cloth,
warm water and a mild deter‐
Step 2
Shake the test paper
to remove the excess
of water.
BEFORE FIRST USE
Step 2
gent.
Step 3
After 1 min, check
water hardness with
the table below.
Step 3
Place the accessories and the
removable shelf supports in
the oven.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
5/24