Line Light Adjustment - Challenge TITAN 230 Technical Service And Parts Manual

3.0 Maintenance Guide
Now perform a cut cycle. After the clamp has contacted the table and while the knife bar
is coming down, read the pressure on the clamp pressure gauge (Figure 18). It should
read 800 psi. If it does not, correct by using the up and down arrow keys. When
finished, press soft-key "D" to exit and go to the minimum pressure set up screen as
shown next:
Perform a cut cycle. After the clamp has contacted the table and while the knife is
coming down, read the pressure on the clamp pressure gauge (Figure 18). It should read
400 psi. If it does not, correct by using the up and down arrow keys. When finished,
press soft-key "C" to return to Send Mode, or soft-key "D" to return to Diagnostics.

3.7.6 Line Light Adjustment

1. Place a wide sheet of paper on the cut stick to view the line light.
2. Using a 9/64" hex wrench, loosen the three line light mounting screws.
3. Slide the line light board forward or backward until you see a 1/16-1/8" beam.
4. Tighten the three screws.
22
5.000
Set Maximum
>
Press /\ to Increase
Press \/ to Decrease
A) Main C) Send
B) Job D) Exit
5.000
Set Minimum
>
Press /\ to Increase
Press \/ to Decrease
A) Main C) Send
B) Job D) Exit