Nautilus Schwinn 470 Assembly Manual / Owner's Manual page 44

Condition/Problem
No speed/RPM reading,
Console displays "Please
Stride" error code
Resistance does not
change (machine turns on
and operates)
Incline does not adjust
(machine turns on and
operates)
sleep mode) while in use
44
Things to Check
Check data cable integrity
Check data cable
connections/orientation
Check magnet position
(requires shroud removal)
Check Speed Sensor
(requires shroud removal)
Check Console
Check data cable integrity
Check data cable
connections/orientation
Check Servo Motor
(requires shroud removal)
MCB (requires shroud
removal)
Check Console
Lower and Upper I/O
Cables (requires shroud
removal)
Incline Adjuster Assembly
(requires shroud removal)
Check electrical (wall)
outlet
Check connection at front
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset machine
All wires in cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
All wires in cable should be intact. If any are visibly crimped or
cut, replace cable.
Be sure cable is connected securely and oriented properly.
Reseat all connections. Small latch on connector should line up
and snap into place.
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
Replace MCB.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
All wires in the cables should be intact. If any are cut or
crimped, replace cable.
Be sure Incline Adjuster Assembly is attached to Incline Motor
drive screw.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace
adapter or connection at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Solution