Table of Contents
Advertisement
EN | User Manual
◊ The dryer should be installed with suffi cient
spacing at the top, sides, and rear, in order to
be able to carry out maintenance work and
change the drying agent without any hindranc-
es (see fi gure).
If in doubt, the installation site must be inspect-
ed by specialists. If you have any queries in this
regard, please contact the manufacturer (see
pag. 4
Transporting the dryer
Remove packaging.
Attach suitable lifting gear to the eyebolts on
the vessels (see fi gure).
Note:
The vessels are fi lled with layers of various desiccants. They should therefore
be transported in an upright position in order to prevent the mixing of these
desiccants, as this could impair the operation of the dryer.
Risk of tilting!
The dryer should only be transported in an upright position. However, this me-
ans that the centre of gravity of the unit is located in the middle of the dryer, so
that there is a serious risk that the unit might tilt over.
Therefore, adhere to the transport instructions outlined as follows.
12
Transportation, installation and storage
Necessary spacing at the top and sides
= min. 1 m
Eyebolt at vessel
KE-MT 120-600
Advertisement
Table of Contents
