Table of Contents
Advertisement
EN | User Manual
Maintenance of the dryer and fault removal
◊ Carry out maintenance work only when the plant has been shut down and depressurised!
◊ The factory settings on the control board in the switchbox must not be changed on any
account without prior approval by the manufacturer.
◊ Bolt connections must be undone with care! Note ram pressure values! Otherwise emerging
media may cause personal injury.
◊ Never carry out any welding on a vessel or change the same in any other way!
◊ Never use pipes and fi ttings as steps or holding points! The components might fracture, or
the distortions which occur may cause internal damage on the dryer. There is a risk of injury
by slipping off the components, components breaking off, and expanding compressed air!
◊ Never leave tools, loose parts or cloths in, at or on the dryer.
◊ Following maintenance work always test all fl ange and bolt connections for leak tightness
and secure seating.
◊ Only use replacement parts that are suitable for the relevant function and meet the techni-
cal requirements stipulated by the manufacturer. This is always the case, if you use original
replacement parts only.
Disassembly and disposal
◊ Dispose all parts of the dryer, the drying agent, and all other operating materials in an
environmentally safe way and in accordance with all current statutory regulations. The waste
code numbers of the drying agents can be obtained from the manufacturer (for the manufac-
turer's address see page "General information" a pagina 4).
8
For your own safety
KE-MT 120-600
Advertisement
Table of Contents
