Bosch MIC440AXWUD14636N Operation Manual page 36

MIC440 Explosion-protected Camera
Number
1
2
3
4
18. Connect the shielded composite cable to terminal block HD3 (and, if necessary, HD6 and
HD7) following the color coding as shown in the figure below, and printed on the PCB.
No ID, Connection/
. Terminal + Pin
1 HD3-1
2 HD3-2
3 HD3-3
4 HD3-4
5 HD3-5
6 HD3-6
7 HD3-7
8 HD3-8
9 HD3-9
10 HD3-10
11 HD3-11
12 HD6-1
13 HD6-2
14 HD7-1
15 HD7-2
Notice!
MIC440 cameras do not have an internal heater.
19. Slide back the cable so that the shield is in the middle of the gland.
20. Tighten the cable gland so that it grips firmly the shielded composite cable. It is important
that the braided cable screen engages with the internal clamps of the cable gland to ensure
correct EMC protection.
Bosch Security Systems, Inc.
Description
Optical Video out
Composite cable
Optional switched video output
Head-end / Telemetry controls
PCB Mark, Description/Function of Connection
Signal
Power Low Voltage Power (Input 1) / AC supply
Power Low Voltage Power (Input 2) / AC supply return
RxB Telemetry I/O to RS-422/485 [Rx +]
Full Duplex RxB/Half Duplex Tx/RxB
RxA Telemetry I/O to RS-422/485 [Rx -] Full Duplex
0v
TxA Telemetry I/O to RS-422/485 [Tx -] Full Duplex
TxB Telemetry I/O to RS-422/485 [Tx +] Full Duplex
Video Video output of optical camera to Control Room
Video 0V Video signal return (optical camera) (ground to
Control Room) (Coax - BNC CN1)
Tamp Sw
Wash [Optional] Washer Drive Signal
AUX1 [Optional] Auxiliary Connection (heater)
AUX2 [Optional] Auxiliary Connection (heater)
-- Video Switched Output to Control Room
(Switched visible/thermal video out signal)
--
Install the MIC Power Supply Unit (PSU) | en
RxA/Half Duplex Tx/RxA
Ground [Drain Wire / Shield]
TxA
TxB
(Coax - BNC CN1)
[Optional] Tamper Switch
Switched video signal ground
Operation Manual
Cable Gland Size
M12
M16
M12
M12
PCB Mark,
Cable Color
Red
Green
White
Yellow
Screen (Black)
Blue
Violet
Core
Screen
Black
Orange
Brown
Grey
Core (Black)
Screen (Black)
2013.11 | 8.1 |
37