Sony PXW-X400KF Operating Instructions Manual page 12

000 12
1. Overview: Name and Function of Parts
7.
AUDIO IN CH-1/CH-2 (audio channel 1 and
channel 2 input) connectors (XLR type, 3-pin,
female)
Connect to audio equipment or a microphone.
8.
Bottom cover
This is provided for protecting the cables
connected to the connectors on the rear panel.
By loosening the screws which retain the cover to
the bottom of the camcorder, you can adjust the
position of the cover depending on the size and
shape of the microphone or audio cable plugs.
After adjusting the position, tighten the screws to
secure the cover.
9.
AUDIO OUT connector (XLR type, 5-pin,
male)
Outputs the audio signals recorded on audio
channels 1 and 2 or audio channels 3 and 4.
The audio signals are selected by the MONITOR
switch.
10.
REMOTE connector (8-pin)
Connect a remote control unit to control the
camcorder remotely.
[Note]
Before connecting/disconnecting the Remote Control Unit
to/from the camcorder, be sure to turn off the camcorder
POWER switch.
11.
SDI OUT 1/2 connectors (BNC type)
Outputs an HD SDI or SD SDI signal (with
embedded audio). The output from this connector
can be turned on/off using Operation >Input/
Output >SDI Out1 Output or SDI Out2 Output in
the setup menu.