Table of Contents
Advertisement
Chapter 6
Certification
• CAN/CSA-C22.2 No. 14-05
Industrial Control Equipment
• CAN/CSA-C22.2 No. 142-M1987
Process Control Equipment Industrial Products
• CAN/CSA-C22.2 No. 213-M1987
Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous Locations
• UL 60950-1
Information Technology Equipment – Safety Part 1: General Requirements
• ANSI/UL 508
Standard for Industrial Control Equipment
• UL 916 4th Edition 2007
Standard for Energy Management Equipment
• ANSI/ISA-12.12.01-2007
Non-incendive Electrical Equipment For Use In Class 1 And 2, Division 2 And Class 3, Divisions 1 And 2
Hazardous (classified) Locations
The device is marked with a CSA symbol that indicates compliance with both Canadian and U.S. requirements.
Copies of the CSA Declarations of Conformity are available via Siemens Industry Online Support:
•
https://support.industry.siemens.com/cs/ww/en/view/109476357
•
https://support.industry.siemens.com/cs/ww/en/view/109476358
Section 6.1.2
ATEX/IEC Ex
This device meets the requirements of the following ATEX/IEC Ex standards:
• IEC/EN 60079-15:2005
Electrical Apparatus for Explosive Gas Atmospheres - Part 15: Construction, Test and Marking of Type of
Protection "N" Electrical Apparatus
It is specifically approved for use in hazardous locations defined as:
• EEx nC IIC T4
• Ex II 3 G
• 12-24 VDC, 2A, Class III
Section 6.1.3
European Union (EU)
This device is declared by Siemens Canada Ltd to comply with essential requirements and other relevant provisions
of the following EU directives:
20
C
US
(General Safety)
(Hazardous Locations)
RUGGEDCOM i800
Installation Guide
ATEX/IEC Ex
Advertisement
Table of Contents
