Table of Contents
Advertisement
36
en | Maintenance
10.9
Installing the air shroud
The air shroud does not require screws for its installation.
Notice!
i
If a 16 DIMM (13.68" x 13") motherboard is used, it is necessary to use the optional
MCP-310-82502-0N air shroud.
To install the air shroud:
1.
2.
3.
To check the air flow:
1.
2.
3.
10.10
Replacing a system fan
Caution!
Hazardous moving parts
Keep away from moving fan blades.
!
The fans might still be turning when you remove the fan assembly from the chassis. Keep
fingers, screwdrivers, and other objects away from the openings in the fan assembly's
housing.
2020.11 | V1.1 | DOC
Make sure that your air shroud matches your chassis model.
Turn off the system and remove the cover.
Place the air shroud in the chassis. The air shroud fits behind the two fans closest to the
power supply.
Make sure there are no objects to obstruct airflow in and out of the chassis. In addition, if
you are using a front bezel, make sure the bezel's filter is replaced periodically.
Do not operate the system without drives or drive trays in the drive bays. Use only
recommended material.
Make sure no wires or foreign objects obstruct air flow through the chassis. Pull all
excess cabling out of the airflow path or use shorter cables. The control panel LEDs
inform you about system status.
Installation manual
DIVAR IP all-in-one 7000 2U
Bosch Security Systems B.V.
Advertisement
Table of Contents
