Table of Contents
Advertisement
DIVAR IP all-in-one 7000 2U
3.3
Control panel elements
The control panel located on the front of the chassis features power buttons and status
monitoring LEDs.
Control panel buttons
Control panel LEDs
The control panel LEDs provide status information about the system.
Power failure
Information
Bosch Security Systems B.V.
Button
Description
The power button is used to apply or remove power from the power supply to
the system.
Note: Turning off system power with this button removes the main power,
Power
but keeps standby power supplied to the system.
To remove all power, unplug the system before performing maintenance
tasks.
The reset button is used to reboot the system.
Reset
LED
Description
This LED indicates that a power supply module has failed.
This LED indicates the system status.
System status
Continuously on and red
Blinking red (1 Hz)
Blinking red (0.25 Hz)
Solid blue
Blinking blue (300 msec)
This LED indicates network activity on GLAN2 when flashing.
NIC2
This LED indicates network activity on GLAN1 when flashing.
NIC1
Description
An overheat condition has occurred. (This
may be caused by cable congestion.)
Fan failure: check for an inoperative fan.
Power failure: check for an inoperative
power supply.
Local UID has been activated. Use this
function to locate the unit in a rack
environment.
Remote UID has been activated. Use this
function to locate the unit from a remote
location.
Installation manual
System overview | en
15
2020.11 | V1.1 | DOC
Advertisement
Table of Contents
