Table of Contents
Advertisement
Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2–13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section on the next page.
Place channels in memory
(Autoprogram)
20
Controls Alarm Adjust Setup
E n g l i s h Français Español
A u t o p r o g r a m
L a b e l : 1 3
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
E n g l i s h Français Español
A u t o p r o g r a m m i n g
L a b e l : 1 3
Channel Memory: 13 Stored
Cable/Air: Cable
A. Hook up an antenna, cable
1 3
or components before you
begin these steps or you will
not be able to add channels
into memory.
B. Press MENU•PROG repeatedly
to select the Setup Menu. This
C e a r
menu is white.
C. Press MOVE
highlight Autoprogram.
1 5
D. Press MOVE
the TV adding all active
channels into memory.
E. Wait until the TV has cycled
through all the channels and
returns to the original channel.
C l e a r
(down) to
(right) to start
Advertisement
Table of Contents
