Table of Contents
Advertisement
Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2--13 appear in the TV's memory when you first turn it on.
"Pne channels available in your area must be programmed
into the TV's
memory when you hook up your TV. Using CHANNEL up or down
allows you to scan through these channels.
"You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed.
Refer to the Add
or Delete Channels section below.
1.
Place channels
in
memory
(AutoProgram)
3ontrols Alarm Ad
13
A. Hook up an antenna or cable
before you
begin
these steps or
you will not be able to add
channels into memory.
B. Press MENU repeatedly to
select the Setup Menu and
highlight Autoprogram.
This
menu is white.
C. Press + to start the TV adding
all active channels into
memory.
D. Wait until the TV has cycled
through all thechannels and
returns t otheoriginal channel.
E. Press DONE.
2. Add or delete channels
13
13
Controls Alarm Adjust S_
A. Press MENU repeatedly
to
select the Setup menu.
B. Press CHANNEL down to
highlight Channel Memory.
C. Press + to underline the
channel number.
D. Select the channel number
you
want to add or delete with the
number buttons.
E. Press + to add or delete a
channel (you will see Stored on
the screen when added and
Erased when deleted).
F. Repeat D and E for more
channels.
G. Press DONE.
18
Advertisement
Table of Contents
