Table of Contents
Advertisement
Using, Advanced Features
Placing
Channels
in Memory (Autoprogramming)
Only channels 2-13 appear in the TV's memory when you first turn it on.
The channels
available in your area must be programmed
into the TV's
memory when you hook up your TV. Using CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed.
Refer to the Add
or Delete Channels section below.
1.
Place channels
in
memory
(Autoprogram)
Controls Alarm
A..
g.
Hook up an antenna,
cable or
components
before you begin
these steps or you will not be
able to add channels
into
memory.
Press MENU repeatedly
to
select the Setup menu. This
menu is white.
C. Press CHANNEL down to
highlight
Autoprogram.
D. Press VOLUME + to start the
TV adding all active channels
into memory.
E. Wait until the TV has cycled
through all the channels
and
returns
to the original channel.
2. Add or delete
channels
Controls Alarm Ad
;ontrols
Alarm Ad
A. Press MENU on the TV front
panel repeatedly
to select the
Setup menu. This menu is
white.
B. Press CHANNEL down
to
highlight
Channel Memory.
C. Press VOLUME + to underline
the channel number.
D. Select the channel number you
want to add or delete with the
number buttons.
E. Press VOLUME + to add or
delete a channel (you will see
Stored on the screen when
added and Erased when
deleted).
F. Repeat D and E for more
channels.
11
Advertisement
Table of Contents
