Table of Contents
Advertisement
When using Mitsubishi equipment, thoroughly read this manual and the
associated manuals introduced in the manual. Also pay careful attention to
safety and handle the module properly.
These precautions apply only to Mitsubishi equipment. Refer to the user's
manual of the CPU module to use for a description of the PLC system safety
precautions.
These "SAFETY PRECAUTIONS" classify the safety precautions into two
categories: "DANGER" and "CAUTION".
DANGER
CAUTION
Depending on circumstances, procedures indicated by
be linked to serious results.
In any case, it is important to follow the directions for usage.
Store this manual in a safe place so that you can take it out and read it
whenever necessary. Always forward it to the end user.
[DESIGN PRECAUTIONS]
Do not bunch the control wires or communication cables with the main
circuit or power wires, or install them close to each other.
They should be installed 100 mm (3.94 inch) or more from each other.
Not doing so could result in noise that may cause malfunction.
At power ON/OFF, voltage or current may instantaneously be output from
the output terminal of this module. In such case, wait until the analog
output becomes stable to start controlling the external device.
SAFETY PRECAUTIONS
(Read these precautions before using.)
Procedures which may lead to a dangerous condition and
cause death or serious injury, if not carried out properly.
Procedures which may lead to a dangerous condition and
cause superficial to medium injury, or physical damage
only, if not carried out properly.
CAUTION
A-1
CAUTION may also
Advertisement
Table of Contents
