Kiwi Camping Kingfisher 2 Pitching Instructions

Kingfisher 2
�1camping Recreational Tent
Model No. KC072-444
PITCHING INSTRUCTIONS
Your tent includes:
14 x pegs (4mm DX 178mm L)
4 x ropes
2 x BLACK fibreglass poles (3590mm x 7.9mm)
1. Select a dry, level site and
clear the ground of any sharp
objects. Remove the tent from
it's carry bag, untie fabric ties
and unroll the tent.
2.
Spread out the floor of the inner
tent and peg out the four main
corners first, ensuring that the
tent is pulled taut and square.
Unzip and open the doors to
make erecting the tent easier.
3. Assemble the two BLACK
fibreglass poles by interlocking
the sections.
4. Connect one end of the
first BLACK pole onto the
pin located on the corner
of the tent, and then
connect the other end of
the pole to the pin on the
corner diagonally
opposite. Clip speed-clips
to pole to help hold the
pole in place.
5. Repeat this for the
second pole so that they
have created an 'X' in the
middle of the tent. Tie the
poles together using the
tie located under the 'X'
on the inner. The inner
tent is now pitched.
Carefully pull the fly up
6.
over the inner tent with
the door lining up at the
front. Tie the ties on
the underside of the fly
around the
corresponding fibreglass
poles to ensure fly is
on correctly.
7. Peg out the four corners
of the fly ensuring there
is space allowed between
the inner and the fly.
8. Peg out the
vestibule with
the front door
closed, and then
continue to peg
any remaining
peg points on the
fly.
9. Finally, rope out the guy ropes and fine tune the fly so
it remains taut and positioned correctly over the tent.

REVERSE THE PROCEDURE TO LOWER THE TENT

PACKING INSTRUCTIONS

Pack the poles and pegs into their bags. Evenly lay out the
outer fly inside the tent inner leaving all doors and windows
open. Fold the inner tent floor from each side to the centre
and in half again. Adjust to the length of the poles. Place
the poles onto the floor and roll them inside so that the floor
is on the outside. Store and pack the tent in it's bag.