Table of Contents
Advertisement
Instruction Manual
Machine usage
Before the first use, adjust the equipment to the best cleaning effect.Before each
use, routine inspection is required:
◆ Whether the seal strip of sewage tank cover comes off
◆ Is the sewage tank cleaned
1. Insert the suction pipe
Insert one end of the suction pipe into the inlet of the sewage tank and the other end
into the exit of the tail flap.This is shown on the right
2. Fill with water
Please observe the water level through the water level pipe. If the water is insufficient,
Please fill it with clear water
◆ Open the lid of the clean water tank
◆Put clean water into the water tank (put the water pipe into the tank first, then open
the water valve, the water temperature is not higher than 50℃ , the water level can be
observed through the water level pipe)
◆ Add detergent, the amountcanbe addedaccordingto theneeds oftheground
◆ Close the water tank cover
3. Water regulation
◆ Open the discharge valve and adjust the water amount according to the actual needs
1. Air suction motor switch:
Turn on the switch and the suction motor will start to work.
2. Main power switch:
Start the switch and the device is in the state of power on.
3. Brush plate switch:
Press this switch and the brush plate begins to work.
4. Voltage display table:
Can be real device power, power increase display during charging process.
5. Back and forth switch:
Start this switch to control the machine forward or backward
6. Emergency stop switch:
This button can be quickly pressed to protect you in case of an emergency.
7. Gas pedal:
Control the speed of the machine by stamping
3
YZ-X5
Advertisement
Table of Contents
