Table of Contents
Advertisement
AP-2 Manual
Magnet Housing
The magnet housing has the following features:
•
A clear mark on the outside that indicates the correct direction of air flow.
•
It is made of anodized aluminum.
•
It has a 1/4-inch FNPT inlet and a 3/8-inch or 1/4-inch FNPT outlet.
•
It handles air pressures from 40 - 200 psi.
Hardware Options
Inlet and outlet openings can be fit with no-mix quick-connects or barb
connections depending on site requirements.
Figure 35 -
Pump Cycle Counter Installation
Page 88
QED Environmental Systems
Advertisement
Table of Contents
Troubleshooting
