Assembly Of The Digital Display - QED AutoPump AP-2 Operation Manual

AP-2 Manual
Assembly of the Digital Display (Figure 36)
Should the digital display be removed and disassembled for any reason, the procedure for
assembling is as follows:
STEP 1 -
STEP 2 -
STEP 3 -
STEP 4 -
Page 92
Seat the digital display (item #4) on the flat of the display seat
(item #5). (See Figure 36)
Slide the cycle counter sleeve (item #2) over the display seat (item #5)
and the bottom lip portion of the digital display (item #4). Both pieces
(the display seat #5 and the digital display #4) should be held in place
by the cycle counter sleeve (item #2).
Align the thumb screw holes.
Screw in the thumb screw (item #3) to hold the Display Assembly
together.
QED Environmental Systems