Table of Contents
Advertisement
2.5
Hardware Installation
2.5.1
Expansion Module Installation
Before installing your expansion module, ensure the system is
powered down and disconnect the power cord from the system. Make sure you have
the expansion module ready to install. See Chapter 1 for expansion module
specifications for compatibility.
Turn the BOXER-8646AI system over so the bottom is facing up. Install each module by
first inserting at an angle (approx 30°), then gently pressing down and securing. Refer
to the images below for guidance on removing the bottom panel, and overleaf for
which slot corresponds with M.2 2280, M.2 3052 and M.2 2230 modules.
Chapter 2 – Hardware Information
25
Advertisement
Table of Contents
