2.5 Hardware Installation
2.5.1
2.5" SATA Drive Installation
Before installing the SATA Drive, ensure the system is powered down and disconnect
the power cord from the system. Make sure you have the SATA Drive ready to install.
See Chapter 1 for SATA drive specifications for compatibility.
St ep 1: Remove the six screws securing the bottom panel of the system, then remove
the bottom panel.
Step 2: Fasten the SATA drive to the Drive Bracket with four screws as shown below. The
data and power connectors should be facing opposite of the bracket notch.
Connectors on
this side!
Chapter 2 – Hardware Information
29