Install Batteries In The Remote; Point The Remote In The Right Direction And Put It In Dvd Or Vcr Mode; Turn On The Tv And Dvd/Vcr - RCA DRC6200N User Manual

Install Batteries in the Remote

1. Remove the battery compartment cover on the back of the remote.
2. Insert new batteries. Match the polarities (+ and –) on the batteries with the diagram on the
remote.
3. Put the battery compartment cover back on the remote.
Important Battery Information
• If you're not going to use the remote for a month or more, be sure to remove the batteries because
they can leak and cause damage.
• Dispose of batteries in the proper manner, according to federal, state, and local regulations.
• Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all
batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to charge
a battery not intended to be recharged.
• Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.

Point the Remote in the Right Direction and Put it in DVD or VCR Mode

When you want the remote to operate the DVD/VCR, point the remote at the DVD/VCR, not the TV. The
remote has to be pointed in the correct direction and toward the correct component in order for the
remote control's signal to communicate with the sensor on the component. Make sure there is a clear
path between the remote control and the component you want to operate, so the signal isn't blocked.

Turn on the TV and DVD/VCR

1. Turn on your TV and tune it to the correct Video Input Channel.
• If you used a coaxial cable to connect your DVD/VCR to your TV, tune the TV to channel 3. Your
TV must be set to channel 3 the first time you set up the DVD/VCR. See page 32 for instructions
on how to change the output channel once you have started setup.
• If you used audio/video cables to connect your DVD/VCR, tune the TV to its Video Input Channel
(see page 55 for help).
2. Press the DVD or VCR button to turn on the DVD/VCR.
• To operate the DVD part, press the DVD button.
• To operate the VCR part, press the VCR button.
3. The default language for the DVD and VCR on-screen displays is English. If you want to change it,
see pages 10 and 35
Chapter 1
Connections and Setup
9