Time Counter; Info Display - RCA DRC6200N User Manual

Time Counter

The time counter shows the actual time used when recording or playing a tape. The time counter helps
locate the beginning or end of recorded events. It resets to 0:00:00 whenever a tape is ejected from
the DVD/VCR.
For example, if you record a 30–minute program at the beginning of a tape, rewind it, and then want
to go to the end of the first program to start another recording:
Hours Minutes
0:30:00
Seconds

Info Display

To find out the status of the VCR, press the INFO button on the remote control. Each time you press
INFO, different information appears on the screen. See the following examples.
Note: The date and time must be set before they can be displayed.
1
STOP
0:30:00
SLP
06/25/2003 WED 03:46PM
On-screen display (times out)
2
0:30:00
Time counter only (does not time out)
Chapter 4
1. Press the INFO button twice to display only the time
counter.
2. Press the CLEAR button to reset the time counter to
0:00:00.
3. Press the remote control's FORWARD button to advance
a tape until the time counter reads 0:30:00.
4. Press the STOP button. This is the approximate end of a
30-minute program (you may want to press the PLAY
button to verify). When the tape is cued correctly, you
can begin recording.
5. Press the INFO button to remove the time counter from
the screen and return to the normal display mode.
1. Press the INFO button to show the on-screen displays.
CH 05
The current time is also displayed in the VCR's front
panel.
2. Press INFO again to have only the time counter remain
on the screen. The time counter is also displayed in the
VCR's front panel for a short time.
VCR Features
continued on next page
29