Install Batteries In The Remote; Point The Remote In The Right Direction; Turn On The Tv And Dvd/Vcr; Complete The General Setup - RCA DRC8320N User Manual

Install Batteries in the Remote

1.
Remove the battery compartment cover on the back of the remote.
2.
Insert new batteries. Match the polarities (+ and –) on the batteries with the diagram inside the remote ' s battery compartment.
3.
Put the battery compartment cover back on the remote.
Important Battery Information
If you're not going to use the remote for a month or more, be sure to remove the batteries because they can leak and cause damage.
Dispose of batteries in the proper manner, according to federal, state, and local regulations.
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same time,
if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged.
Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.

Point the Remote in the Right Direction

When you want the remote to operate the DVD/VCR, point the remote at the DVD/VCR, not the TV. The remote has to be pointed in the correct
direction and toward the correct component in order for the remote control's signal to communicate with the sensor on the component. Make sure there is
a clear path between the remote control and the component you want to operate, so the signal isn't blocked.

Turn on the TV and DVD/VCR

1.
Turn on the DVD/VCR - press the ON button on the remote.
2.
Turn on the TV and tune it to the correct Video Input Channel (if you don' t know how to access the Video Input Channel on your TV, go to page
22 for help). If you used coaxial cable to connect to your TV, tune your TV to channel 3 or 4.
You ' ll know you are on the right Video Input Channel when you see the DVD recorder menu for the language selection (see below).
Left arrow
button
Down
arrow
button
Use the arrow buttons on the remote
to move through on-screen menus and
highlight different options. Press the
ENTER button to select a menu item that is
highlighted.
Chapter 1: Connections and Setup

Complete the General Setup

You can access the setup screens by pressing the SETUP button on the remote control.
Use the remote control to follow the on-screen instructions. The arrow buttons move the
on-screen highlight in the corresponding directions on the screen (up, down, left, right).
Up arrow
Press the ENTER button to select a highlighted item.
button
ENTER
button
Right
arrow
button
Graphics contained within this publication are for representation only.
19