Renkforce RF-AP-N300Mini User Manual page 81

My network device can't
access the Internet.
My wireless extender
has a poor signal from
my access point/router.
Can I use the same SSID
as my current gateway
router for my Wi-Fi
extender?
as it is safely possible to do so. Call your dealer of purchase
for help.
a. Ensure that your broadband router is fully functional.
b. Switch off both your network device and wireless extender
and switch back on again.
c. Ensure that the wireless extender is powered on (check the
PWR LED).
d. On the browser based configuration interface home page,
check "Status" under "Wireless Configuration". It should
be "Connected" – if it is "Disconnected" then this means
the wireless extender is not connected to your
router/access point.
The best location to place the Wi-Fi extender is one which is an
open space, roughly in the middle between your router and the
Wi-Fi dead zone, and where the Wi-Fi extender LED displays
"Excellent" signal strength.
a. Keep the extender away from other radio devices such as
microwaves or wireless telephones.
b. Do not put the extender in the corner of a room or
under/nearby metal.
c. It is recommended to plug the extender directly into a wall
socket.
d. Ensure there are as few obstacles as possible between the
extender and the access point/router.
Yes, but it is not recommended as it will be difficult to
distinguish between two SSIDs with the same name.
78