Setup Wizard - Renkforce RF-AP-N300Mini User Manual

III-3-2. Setup Wizard
switch the device to a different operating mode. Select "Setup Wizard" or "Switch to
Router/Access Point/Range Extender/Wireless Bridge/WISP mode" and then click "Run
Wizard" to begin.
Switch to Access Point/ Wi-Fi
Extender/ Wi-Fi Bridge mode
Switch to Access Point/ Wi-Fi Extender/ Wi-Fi Bridge mode:
1.
Follow the on-screen instructions to back up your current settings and then reset the
device back to its factory default settings.
2.
After the device has reset you will see the screen below. Close your browser and open
it again.
3.
Follow the on-screen wizard to setup your device in a different mode. Refer to II.
Installation Step 3 onwards for help if needed.
If you don't see the "Get Started" screen, try reconnecting to
the renkforceEXT.setup ** SSID and go to
http://renkforce.setup in a web browser.
You can run the setup wizard again to reconfigure the basic
settings of the device, or you can run a wizard to help you
This wizard will help you to switch the device to a
different operating mode: Access Point mode, Wi-Fi
extender mode, Wi-Fi bridge mode (see below).
32