Safety Instructions - Parkside PISG 120 B3 Operation And Safety Notes

Introduction / Safety instructions
Maximum effective input
current:
Rated value of the open
circuit voltage:
Protection class:
Weight:
Duty cycle X:
Falling characteristic
Material thicknesses
which can be welded:

Safety instructions

Please read the operating instruc-
tions with care and observe the
notes described. Familiarise your-
self with the device, its proper
use and the safety instructions
based on these operating instruc-
tions. The rating plate contains
all technical data of this welding
device; please learn about the
technical features of this device.
„
packaging material away from
small children. There is a risk
of suffocation!
This device may be used by
„
children aged 16 years and
older, and by persons with
reduced physical, sensory or
mental capacities, or a lack of
experience and knowledge,
if they are supervised or have
been instructed in how to use
8
GB
I : 11 A
1eff
U : 80 V
0
IP21S
approx. 3 kg
30% at 40 °C
and 120 A
1.5 mm –
3.0 mm
Keep the
the device safely and under-
stand the dangers that may
arise when using it. Do not
allow children to play with the
device. Cleaning and day-to-
day maintenance must not be
performed by children without
supervision.
Repairs or/and maintenance
„
work must only be carried out
by qualified electricians.
Only use the weld cable
„
provided in the scope of
delivery.
During operation, the device
„
should not be positioned
directly on the wall, covered or
jammed between other devices
so that sufficient air can be
absorbed through the ventila-
tion slats. Make sure that the
device is correctly connected
to the supply voltage. Avoid
any form of tensile stress of
the power cable. Disconnect
the plug from the socket prior
to setting up the device in
another location.
If the device is not in opera-
„
tion, always switch it off by
pressing the ON/OFF switch.
Place the electrode holder on
an insulated surface and only
remove it from the holder after
allowing it to cool down for
15 minutes.