Environment With Increased Electrical Hazard - Parkside PISG 120 B3 Operation And Safety Notes

Please familiarise yourself with
„
the welding safety instructions.
Also refer to the safety instruc-
tions of your welding device.
Always wear a welding mask
„
while welding. If it is not
used, you could sustain severe
lesions to the retina.
Always wear protective cloth-
„
ing during welding operations.
Never use the welding mask
„
without the protective screen.
Regularly replace the protec-
„
tive screen to ensure good
visibility and fatigue-proof
work.
Environment with
z
increased electrical
hazard
When welding in environments
with increased electrical hazard,
the following safety instructions
must be observed. Environments
with increased electrical hazard
may be encountered, for example:
In workplaces where the space
„
for movement is restricted,
such that the welder is working
in a forced posture (e.g.:
kneeling, sitting, lying) and is
touching electrically conductive
parts;
In workplaces which are
„
restricted completely or in
part in terms of electrical
conductivity and where there is
a high risk through avoidable
or accidental touching by the
welder;
In wet, humid or hot work-
„
places where the air humidity
or weld significantly reduces
the resistance of human skin
and the insulating properties
or effect of protective equip-
ment.
Even a metal conductor or
scaffolding can create an
environment with increased
electrical hazard.
In this type of environment,
insulated mats and pads must
be used. Furthermore gauntlet
gloves and head protection made
of leather or other insulating
materials must be worn to insu-
late the body against Earth. The
welding power source must be
located outside the working area
or electrically conductive surfaces
and out of the welder's reach.
Additional protection against a
shock from the mains power in
the event a fault can be provided
by using a fault-circuit interrupter,
Safety instructions
GB 13