Table of Contents
Advertisement
W 125
the gun body's 3 guide rails.
the gun body's 3 guide rails.
2) Put the air cap onto the nozzle and tighten it using the union nut.
3) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
4) Insert the suction tube with container seal in the gun body.
11. Maintenance
WARNING! Never operate the machine without the air lter; dirt could be
sucked in and interfere with the function of the machine. Disconnect plug
before changing parts.
•
Pull the air lter out of the gun and re-insert cleaned or new air lters (Fig. 10).
12. Spare Parts List
Pos.
Designation
1
Spray gun front part complete incl. 600 ml container
2
Set comprising union nut, air cap, nozzle
3
Container with cover
4
Air lter
13. Correction of Malfunctions
Problem
Problem
No coating
material
emerges from
the nozzle
Coating
material drips
from the nozzle
Atomisation too
coarse / Spray
jet pulsates
Spare Parts List (Fig. 11)
Cause
Cause
•
Nozzle clogged
•
Feed tube clogged
•
Material volume too small
•
No pressure build-up in container
•
Nozzle worn
•
Viscosity of coating material too
high
•
Material volume too large
•
Nozzle contaminated
•
Air lter heavily soiled
•
Too little pressure build-up in
container
Order No.
2419438
2419415
2370528
2414439
Remedy
Remedy
•
Clean
•
Clean
•
Increase the material
volume
•
Tighten container
•
Change
•
Thin
•
Reduce the material volume
•
Clean
•
Change
•
Tighten container
GB
11
Advertisement
Table of Contents
