Table of Contents
Advertisement
Playback
Playback Operation
1. Set the CH3/CH4 switch on the
RF output adapter to channel
CH3 or CH4.
2. Turn on the TV, and tune it to the
same channel you selected with the
RF output adapter's CH3/CH4 switch.
3. Press and hold the small button on the
CAMERA/OFF/VCR switch while you
slide it to VCR.
Viewing What the Camcorder Is Recording
1. Turn on the TV and tune it to channel
3 or 4. Turn the TV's volume down to
prevent a high-pitched squeal caused
by feedback.
2. Set the CH3/CH4 switch on the RF
output adapter to the same channel
you selected on the TV.
Normal TV Viewing
For normal TV viewing, leave the RF
output adapter hooked up to the TV.
Disconnect the adapter's plug from
Note to Cable TV Installer
This reminder is provided to call your attention to Article 820-40 of the
National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that
provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building as
close to the point of cable entry as practical.
4. Press PLAY on the camcorder.
• During playback, use the playback
features described on page 47.
5. Press STOP/EJECT on the camcorder
when you are finished.
3. Press and hold the small button on the
CAMERA/OFF/VCR switch while you
slide it to CAMERA.
4. Press the REC/PAUSE button to begin
recording. You can watch what the
camcorder is seeing (or recording)
on the TV screen.
the camcorder or turn the camcorder's
power off.
51
Advertisement
Table of Contents
