Table of Contents
Advertisement
Product description
The UVpro Disinfection Box is made out of powder-coated sheet steel. For an even irradiation with high
efficiency, the interior is completely lined with special reflective VA sheet metal. 4 UVC beams (4 x 24 W), two
on the floor and two on the ceiling of the unit, ensure maximum performance and short exposure times.
The emitter units include UVC tubes, fixed with stainless steel brackets, an electronic ballast that is mounted
on the side wall of the box, an on-/off- switch and a safety cover switch. The power is supplied via power
cable.
The disinfection box must be inserted into an outlet via 230 V cable. To put the unit into operation, the red
switch on the front of the unit must be operated. The setting of the exposure time can be changed with the
control dial that is also placed on the front side of the unit. To start the disinfection process (ignition of the
tubes), the green button must be pushed.
Direct connection or with UVpro monitoring units
- UVpro CU1
- UVpro UVC-Line 8/16/24
- Network, direct
orca GmbH
The optional, available control unit CU1 serves as a UVPro monitoring
device. More information can be found in the documentation belonging
to this monitoring unit.
The optional, available control unit UVC-Line 8/16/24 serves as a
monitoring unit for more than one UVpro device. More information can
be found in the documentation belonging to this to this monitoring unit.
230 V
. Securing the connection via a residual current circuit
±10 %
AC
breaker (30 mA) is mandatory!
www.orcagmbh.de
Entkeimungsbox EKB 100
Seite 9 von 20
Advertisement
Table of Contents
