Sensor Detection From Connected Equipment; Option Output From Ip Video Intercom Adaptor; Balloon Notification - Aiphone JKW-IP Operation Manual

5-1-7 Sensor Detection from Connected Equipment

You will be notified by the PC Application if sensors
connected to the master monitor station and IP Video
Intercom Adaptor are activated.
1.
If a sensor detects an abnormality, or the connected call
button etc. is pressed, the Sensor Detection Tone occurs.
、 、 、
Sensor:
1 2 3 4
MESSAGE： <Adaptor Name> EXTERNAL INPUT
or
<Adaptor Name> EXTERNAL INPUT <No.>
2.
Click [OFF].
・
The Sensor Detection Tone stops and the sensor indicator
turns off.
・
The Sensor Detection Tone can also be stopped in the
following situations.
Sensor Detection Tone Recovery
External (Sensor) input
If the input latch setting is "30 sec.",
IP Video Intercom
then it automatically stops after 30
Adaptor external input
seconds.
Stopped by the master monitor station.
Master monitor station
If the input latch setting is "30 sec.",
external input
then it automatically stops after 30
seconds.
*1 However if the notification tone sounding time is set to
"Continuous" in the sensor input settings of the master
monitor station, the sensor indicator remains on until
recovery.
MEMO
• For the sensor input settings, refer to "Sensor Input Settings"
on P.24 .
・
If the check mark is removed from Sensor Detection Tone
in "Event Notification Settings"
Tone will not occur.
・
If sensors are activated during communication, the Sensor
Detection Tone will not occur.
、
(Blue)
M
Description
*1
, the Sensor Detection
P.36

5-1-8 Option Output from IP Video Intercom Adaptor

You can operate equipment connected to the IP Video Intercom
Adaptor from the PC Application.
1.
Click [OPTION].
MEMO
The [OPTION] button turns green while being operated.
•
• To perform option output operations, you need to set the
Encryption Key.
* Depending on the communication delay, the timing of
the button turning green and the actual control timing
may differ.
5-1-9 Balloon Notification
When an event occurs, a balloon notification is displayed on
the PC screen.
Balloon Notification Content
Notification
CALL FROM DOOR
CALL FROM ROOM ST
EXTERNAL INPUT
CANNOT RECORD.
SPACE IS FULL.
MEMO
If there is not enough free space on the hard disk drive during
•
a door call, the message "CANNOT RECORD. SPACE IS
FULL." is displayed.
The balloon notification disappears automatically when
•
the computer is operated. The balloon notification also
disappears if you click it while it is displayed.
See "Event Notification Settings" for Balloon Notification
•
settings. P.36
"CANNOT RECORD. SPACE IS FULL." is displayed even
•
when balloon notification is set to off.
45
PC Application Basic Operations
CALL
Event Content
Indicates a call from a door station.
Indicates a call from a master monitor
station.
Indicates external input detection.
Displayed when there is not enough
free space on the hard disk drive.