Zoom/Wide, Pan & Tilt - Aiphone JKW-IP Operation Manual

5-1-3 Zoom/Wide, Pan & Tilt
By using the following steps, the monitor screen of the PC
Application can be switched between a wide picture and a
zoom picture.
• Calling from the door station
• Entrance monitoring
• Communicating with the door station
By using Pan & Tilt when a zoom picture is displayed, a
wide picture can be split into 9 images and displayed as
1 picture.
MEMO
• If the door station is operated from another PC Application
or a master monitor station at the same time as Zoom/Wide
or Pan & Tilt, the operation may not be enabled, due to
communication overlap and control processing.
Zoom/Wide switching
1.
Click [ZOOM / WIDE] ( j ) when the image is displayed
on the PC Application screen.
Zoom picture
・
The screen switches between the zoom picture and the wide
picture each time you click [ZOOM / WIDE].
MEMO
• If visitors are not displayed in the center of the screen during
Zoom, click [ (Pan & tilt)], and then move the screen.
• When the screen switches from a wide picture to a zoom
picture, the image from the position preset by the master
monitor station is displayed.
Depending on the properties of the door station camera,
the wide screen may appear more distorted than the
zoom screen, but this is not a malfunction.
1
Wide picture
Pan & Tilt operation
1.
(Pan & tilt)] ( k ) pqtu buttons while a
Click the [
zoom picture is displayed.
・
The target image is displayed.
・
You can move the image diagonally by clicking the [
& tilt)] diagonal buttons.
Moving the image with the [
41
PC Application Basic Operations
2
(Pan & tilt)] button
(Pan